. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE will leak. But if the filter 13. Loosen the knob of feed pump (5), pull it out, then pump it in and out until the movement becomes heavy. the plug at the top of the fuel fuel, use the same procedure to damage or embedded 4 - 69 Replace inner seal (4) with a NOTICE Do not fill the new filter cartridge Remove c ap (B) and install the fil 8. When i nstalling, tighten until the packing surface contacts the seal surface of the filte turn or more.
ter cartridge is tightened too strong, the packing will be damaged and fuel If the fil cartridg e is tightened too loo se, fuel also will lea k from the gap of the packing portion So whe n tightening, observe the correct tighteni ng degree. o the OPEN position (O). ge (2), bleed the air. l pre-filter is tightened securely. correct amount again. 9. Turn th e valve (1) at the bott om of the fuel tank t 10. After co mpleting the replace ment of filter cartrid 11. Check t hat drain valve (3) at the under of the fue When if fuel leak from the dr ain hose, tighten the Bleed the a ir as follows: 12.
Fill the f uel tank with fuel (to the position where t REMARK It is not pre-filter After the operate feed pump (5) and bl 14. Push in the knob of feed pu mp (5) and tighten it. 15. After re placing the filter cartr idge, start the engin e and run it at low idling for 10 minut Check f or leakage of oil from the filter seal surfac e. If any oil is leaking, check the tighte If there is still oil leakage, re peat Steps 1 - 4 to remove the filter cartridge, and if an foreign material in the packin g surface is found, r eplace it with a new cartridge and rep it.