MAINTENANCE - Electrical System 7. Replace access cap if removed earlier in this procedure. 8. Replace the access panel, then close and secure the hood. Final Checks After everything is reconnected, check the replaced light for operation. Have your headlights periodically checked for proper alignment by dealer. Keep your headlights clean using only mild soap and water (see Maintaining Headlight Performance). A dirty headlight reduces performance and creates glare. Headlight Assembly CAUTION When replacing a halogen bulb, do not touch the globe with your fingers. Oils or other contaminates on the skin can result in early bulb failure. 1. Open the hood and secure it in the open position. 2.
Locate and open the access panel on the inside of the fender liner (see Access Door graphic). 3. If replacing the low or high beam bulb, unscrew and remove the access cap covering that bulb: (2) or (5). 4. Unlock bulb from behind by turning socket (and its wired connector) a quarter-turn counterclockwise, then withdraw bulb and socket from seat. 5. Pull bulb from socket and insert replacement. Dispose of old bulb. Do not touch bulb globe with fingers. 6. Reinsert bulb and socket by lining up the tab on the socket with the slot in the headlight housing, then insert and turn clockwise to lock. 5 1. Turn signal socket 2. Low beam bulb access cap 3.
Daytime running light (DRL) and parking light socket 4. Adjustment knob (Dealer use ONLY) 5. High beam bulb access cap Aiming Headlights The headlights were properly aimed at the factory to meet safety specifications. If the headlights need to be adjusted, please have an authorized dealership aim the headlights. Fuses, Circuit Breakers and Relays Fuses, circuit breakers, and relays are located in the Power Distribution Center (PDC) to the left of the steering column, Y53-6110-1A1 (01/21) 259