PACCAR 579 — Vehicle CAN Bus

MAINTENANCE - Electrical System behind the clutch pedal. Additional fuses are located in the engine compartment (driver’s side firewall) and also in the sleeper (driver’s side of vehicle) under the bunk storage compartment. Refer to the fuse labels affixed at each fuse panel location (generally under the fuse panel cover) for information about the location and amp ratings of each circuit. Vehicle CAN Bus Your vehicle is equipped with a CAN bus electrical system. Because of how the electrical system is designed it is important that any accessories added after the vehicle is built are installed only on the K- CAN or the S-CAN.

These dedicated CANs are provided on the driver's side of the cab, near to the interior fuse panel. Access to the K-CAN and S-CANs is provided by two RP1226 connectors. DO NOT tap into, connect to, tamper with, or splice into any CAN network other than the K-CAN or the S-CAN. Connecting to a unapproved CAN network may trigger CAN fault codes. cause the circuit to overheat when a short exists, which could lead to equip- ment damage and/or personal injury. NOTE Polyswitches/circuit breakers are al- lowed in certain locations as indicated by the label on the fuse box. In these applications, a fuse may be used in- stead of a circuit breaker.

Altering the Electrical System Refer to a wiring diagram for your chassis before adding electrical options to ensure proper electrical system performance. 5 CAUTION WARNING Follow all manufacturers' circuit pro- tection recommendations for the com- ponents and wires being added. Fail- ure to comply may result in equipment damage. CAUTION DO NOT replace a fuse with a fuse of a higher rating. Doing so may damage the electrical system and cause a fire. Failure to comply may result in proper- ty damage, personal injury, or death. Connecting to an unapproved CAN network may trigger CAN fault codes.

The manufacturer will not warrant fail- ures or damage caused to CAN net- work components when the failure or damage is a result of improper con- nections to the CAN network. WARNING NOTE Never install a circuit breaker/poly- switch in a location indicated for “fuse only.” Using a polyswitch (circuit breaker) in a fuse-only circuit may If you are unfamiliar with proper elec- trical repair practices and procedures, see your authorized dealer for assis- tance. 260 Y53-6110-1A1 (01/21)