MAINTENANCE - Noise and Emission Control How to Replace Air Conditioner Filter Inspect and clean cab air filter element every 3-6 months of service. Depending on the operating environment, if air flow from the air conditioner and heater is less efficient or windows fog easier, you may need to replace the cab air filter. 1. Tilt the hood open. 2. Locate air intake housing at passenger rear corner of vehicle under the rain tray. 3. Locate filter cover labeled "OPEN" with an arrow pointing rearward in vehicle. Slide filter cover rearward in vehicle until you are able to remove the cover. 4. Remove and inspect filter referring to maintenance interval schedule. 5.
Replace filter in housing taking care to align the airflow direction that is indicated on the side of the side of the filter element with the airflow direction that is clearly marked on the air intake housing. 6. Replace the filter cover on the air intake housing and slide the cover forward in vehicle. An audible snap sound can be heard when the cover is correctly in place. If the snap feature is damaged there are two screw features that may be utilized to retain the cover in place. 7. Close and secure hood of vehicle.
Noise and Emission Control Replace the Recirculation Air Filter Please contact an authorized dealer when the service interval is required to inspect the cabin recirculation air filter. There are specific components on the vehicle that are designed to meet certain Environmental Protection Agency (EPA) emissions and noise regulations. To maintain conformance with the regulations, these components need to be functional and properly maintained. 5 Sleeper HVAC Air Filter 1. Lift the sleeper bunk to expose the sleeper HVAC module. 2. Find the retention tab at the side of the filter element and move it to release the filter.
Moving this tab will allow the filter to be removed in an upward direction. 3. Align the airflow direction that is indicated on the side of the filter element such that it points into the HVAC housing. 4. Insert the filter and make sure the retention tab has re-engaged to secure the filter. 5. Close the bunk. Noise Emission Warranty Peterbilt warrants to the first person who purchases this vehicle for purposes other than resale and to each subsequent purchaser that this vehicle as manufactured by Peterbilt, was designed, built, and equipped to conform at the time it left Peterbilt's control with all applicable U.S. EPA Noise Control Regulations.
This warranty covers this vehicle as designed, built, and equipped by Peterbilt, and is not limited to any particular part, component, or system of the vehicle manufactured by Peterbilt. Defects in design, assembly, or in any part, component, or system of the vehicle as manufactured by Peterbilt, which, at the time it left Peterbilt's control, caused noise 280 Y53-6110-1A1 (01/21)