MAINTENANCE - Noise and Emission Control emissions to exceed Federal standards, are covered by this warranty for the life of the vehicle. Engine Removing or rendering engine speed governor inoperative so as to allow engine speed to exceed manufacturer's specifications Inspecting Noise and Emission Components If, during periodic inspection and maintenance of other systems and components, it is found that parts of the noise control system require attention, we recommend that those parts be inspected at more frequent intervals to assure adequate maintenance and performance.
The following instructions are based on inspection of the noise control system at regular intervals as indicated in the Noise Control System - Maintenance Log on page 282. Air Intake System Do all checks and maintenance procedures listed in this manual under engine air intake system and air filter housing. Check the induction tubing, elbow connections, clamps, brackets, and fasteners for deterioration, cracks, and security. If you find an air leak anywhere between the air filter housing and the engine, repair that leak immediately. Tampering with Noise Control System Modifying ECU parameters Federal law prohibits the following acts or the causing thereof: 1.
The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement, of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use, or 2. The use of the vehicle after such device or element of design has been removed or rendered inoperative by any person. Among those acts presumed to constitute tampering are the acts listed below:
Exhaust System Removing or rendering inoperative exhaust system components Fuel System Removing or rendering engine speed governor inoperative, allowing engine speed to exceed manufacturer's specifications Removing of air signal attenuator on engines equipped with this device 5 Removing of diesel exhaust fluid tank and system Inner Fender Shields and Cab Skirts Removing shield or skirts Cutting away parts of shields, skirts or damaged or loose portions of shields or skirts Noise Insulating Blankets Removing noise insulators from engine block or from around the oil pan Cutting holes in, or cutting away part of noise insulators Air Intake System Removing or rendering inoperative the air filter housing/silencers or intake piping Removing hood-mounted noise insulation Engine Cooling System Removing or rendering the fan clutch inoperative Removing the fan shroud Y53-6110-1A1 (01/21) 281