E-l: INSTALLATION OF ARM CYLINDER FOOT PIN 1. Remove the stopper fitted to the boom, then re 4. Raise the boom with a crane, align the pin hole at move the arm cylinder foot pin. the boom end with the arm cylinder foot hole, then push in the pin. C?l kg Arm cylinder foot pin: 92 kg 6 Inside of bushing * Use a forcing screw (Dia. = 16 mm, Pitch = 2.0 mm) to remove the pin. Anti-friction compound (LM-P) 2. Set the 2 arm cylinders horizontal and lay on CT?Tl kg Boom assembly: 6700 kg wooden blocks. * Assemble so that the greasing hole in the arm cyl- inder foot is facing down. & kg Arm cylinder assembly: 610 kg 5. install on the left and right in the same way. 3.
Insert O-rings (%07000-12130 x 4) in the O-ring grooves of the 2 bushings of each cylinder at the arm cylinder foot. 6. Install the stopper. 7. Using a nylon sling, secure the arm cylinder with a lever block. 98