E-7: RELEASING PRESSURE FROM HYDRAULIC CIRCUIT When removing the hydraulic piping, always release the pressure as follows. 1. Leave the safety lock lever in the FREE position. 2. Remove the cap of the hydraulic tank. 3. Start the engine, run for approx. IO seconds, then * Do not run the engine above 1000 rpm. stop the engine. * Keep the control levers at neutral. * Raise the safety lock lever and leave it in the FREE position. 4. After stopping the engine, operate the work equip- seconds to release the remaining pressure in the ment levers to the end of their stroke within 5 - 6 * Repeat Steps 3 and 4 three times. A When removing the oil filler cap from the travel circuit.
hydraulic tank, turn it slowly to release the internal pressure, then remove it. 5. l When the remaining pressure has been released, install the oil filler cap on the hydraulic tank to l Lower the safety lock lever to the LOCK posi- prevent dust from getting in. tion. 106