Komatsu — E-10: FLUSHING WORK EQUIPMENT PIPING

E-10: FLUSHING WORK EQUIPMENT PIPING Purpose To remove the dirt and dust which gets into the system during assembly of the attachments, work equipment, and disassembled parts of the body. Flushing is carried out on the machine when it is shipped fromthefactory. 1. Flush the system. (When doing this, do not move the control levers Run the engine at low idling for 30 minutes. in the operator’s compartment.) Run the engine at mid-range speed for 30 min- utes. (When doing this, do not move the control levers in the operator’s compartment.) control levers as follows.

Run the engine at high idling and operate the 1 BOOM RAISE 1 -+ 1 BOOM LOWER 1 -+ vIN( + ~ + [BUCKET TILT I + [BUCKET DUMP] + [BOTTOM OPEN I-+ [BOTTOM CLOSE 1 Hold the lever at each position for 1 min. - 1 * When operating the control levers, raise the min. 30 sec. Repeat this pattern 4 - 5 times. hydraulic safety lock and set it to the FREE position. * If the filter caution lamp on the monitor inside the operator’s cab lights up during flushing, stop the engine immediately and replace the flushing element. with the standard element (07063-01210). If no special flushing element is available, replace 113