E-l 7: INSTALLATION OF BUCKET ASSEMBLY 1. Remove the bucket-arm connecting pin (fixed to to the bucket). the bucket) and bucket-link connecting pin (fixed * Use a forcing screw (Dia. = 16, Pitch = 2.0 mm) to remove the pin. 2. Start the engine, run at idling and operate the boom and arm cylinders slowly to align the position of the holes for the bucket-arm connecting pins. * When operating the cylinder, extend it slowly. Do not operate the cylinder stroke. * At first there is air inside the cylinder, suddenly or operate it to the end of its first ten seconds. In such cases, do not so the cylinder may not move for the operate the lever to the end of its travel.
* Set the arc/horizontal selector siwtch to arc digging. 121