Komatsu — E-25: INSTALLATION OF BOOM FOOT POTENTIOMETER

E-25: INSTALLATION OF BOOM FOOT POTENTIOMETER Tools and facilities required 8. After completing adjustment of the boom foot Part Name Q-Y the Econoseal connector (CN-42). A When removing or installing the Econoseal con- potentiometer, remove the T-adapter and connect Digital voltmeter 1 nector, turn the main switch OFF first. 3-pin T-adapter 1 1. Extend the bucket and arm cylinders fully, and the ground. lower the boom to put the bucket in contact with 2. Stop the engine. (Starting switch OFF) 3. Install shaft (15) (%2lN-06-11150) to the boom foot with 2 bolts (16) (%OlOlO-51230) and 2 washers (17) (-X01643-31232). 4.

Remove cover (191, then install the potentio- meter sub-assembly to the revolving frame with 3 bolts (11) (.X01011-51205) and 3 washers (12) (% 01643-31232). the notch in lever (13). When doing this, assemble so that shaft (15) enters 5. Connect boom foot Econoseal connectors (CN-42: for boom potentiometer; CN-45: for working lamp; CN-43: for arm potentiometer). 6. A When removing or installing the Econoseal connector, turn the main switch OFF first. Install a 3-pin T-adapter to the Econoseal connector (CN-42) of the boom foot potentiometer. A When removing or installing the Econoseal connector, turn the starting switch OFF first. 7.

Start the engine, extend the boom cylinder fully, set the arc/horizontal selector switch to the horizontal digging mode, then check that the voltage between @and @ of the T- d a ap er is 4.27 * 0.08V. (Start- t ing switch ON, engine stopped) If the voltage is not 4.27 + O.O8V, loosen bolts (3) and rotate the potentiometer slightly to adjust the (01010-50612 x 2) mounting the potentiometer, voltage to 4.27 f 0.08V. then tighten bolts (3). Reference value potentiometer when the boom cylinder is at MIN. [Voltage between @and@ of the boom foot (Fully retracted)] = 1.25 f 0.08V 136