Komatsu — E-24: CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL

E-24:CHECK OIL LEVEL IN HYDRAULIC TANK. ADD OIL Run the engine at low idling, retract the arm cyl- boom so that the bottom of the bucket is in contact inder and extend the bucket cylinder. Lower the with the ground, then stop the engine. to the end of its stroke in each direction to release Operate each control lever (work equipment, travel) the internal pressure. 3. Check the oil level in sight gauge 0. 4. If the oil level is not between the H and L lines on sight gauge 0, add engine oil (CD class SAEIOW filler 0. (IO mm in height is 11 liters) regardless of ambient temperature) through oil * Do not add oil above the H line.

*& + The linside of the tank is under pressure, so loosen the cap gradually, and leave for several minutes to release the air pressure completely before taking off the cap. * The oil level differs according to the oil tem- perature, so use the following as a guide. * Before operation: (oil temperature: 10 - 30°C) Near L line * During operation: Near H line (oil temperature: 50 - 80°C) 134