4. Adjustment Methods 2) When making the path of horizontal digging face up or down compared to the level of the 1) When path suddenly rises at the beginning of horizontal digging. machine. When path suddenly goes down at the begin- ning of horizontal digging. Turn adjustment trimmer VRl to make the path horizontal. It is also possible to set the direction facing up and down to meet the preferences of the user. However, it is not a) When path suddenly rises give angles such as used in slope finishing. possible to make big changes in the angle to (Possible adjustment range: Approx.
+3”) f - -- ----\ Path direction of the work equipemnt path is as The relationship between trimmer VRl and the i Starting point shown below. When path moves UP, turn VRI CLOCKWISE. TERCLOCKWISE. When path moves DOWN, turn VRI COUN- Carry out this adjustment at the ehight most b) When path suddenly goes down tion. (Note: If the arm top pin height is more commonly used by the bucket in actual opera- Starting point than 2.5 m, the horizontal digging control does not work.) -_ -4- &----w--N Pat,., Example: Facing down __-Tlpg-L-7__ -4Y-F ?=77?
.$L ----- In the horizontal digging mode, when fine control in the ARM IN direction is carried out from where the arm is nearly perpendicular, top pin does not go up and down as shown in adjust trimmer VR6 so that the path of the arm the diagram above. The relationship between trimmer VR6 and the up and down movement of the arm top pin is as shown below. If arm top pin goes UP, turn trimmer VR6 CLOCKWISE. If arm top pin goes DOWN, turn trimmer VR6 COUNTERCLOCKWISE. 144