2) Adjustment trimmer window The adjustment trimmer window is a window 3. Precautions when adjusting 1) Stop the machine on level ground when ad- with a cover held by four screws. When adjust- 2) justing. trimmers as shown in the diagram. Turn the ing, remove this cover. inside, there are seven When removing the screws from the adjustment trimmer window, be careful not to lose them. trimmers indicated where necessary. 3) dirt or dust must be allowed to get inside the No water, oil, metal particles (screws, etc.) or * VRI: When carrying out horizontal digging operations, this is used to adjust the adjustment must not be carried out when it is adjustment trimmer window.
For this reason, height of the work equipment move- ment so that the horizontal digging can raining or snowing. Always turn the starting switch OFF before be carried out at a higher or lower posi- 4) turning any trimmer. VR2: tion than the machine level. With the bucket angle compensation, 5) or cross head screwdriver. If force is used with When turning the trimmer, use a small flat head this trimmer is used to make the com- pensation (angle) larger or smaller. tip, the screw groove will be damaged and it other tools or with a tool which has a thicker VR3: when carrying out horizontal digging To prevent shock at the stroke end will become impossible to turn the trimmer.
(Use jeweler’s screwdrivers) operations, the horizontal path moves 6) When turning the trimmer, be careful not to let slightly upward near the end of the stroke. Use this trimmer to adjust when the screwdrive rtouch any other parts inside the controller. changing the position for the upward movement. at the temperature at which it is actually used. Carry out the adjustment with the hydraulic oil VR4: adjustment; therefore, never turn it. This trimmer basically does not need cedure given in Section 4 Adjustment Methods. Carry0 out adjustment according to the pro- VR5: This trimmer can be used to change the Do not carry out any adjustment for items trolling horizontal digging.
If it is response of BOOM LOWER when con- where there is no problem. After completion of adjustment, always put the cause hunting (vibration) in the work turned too far clockwise, it is liable to cover back on the adjustment trimmer window and fasten it with the four screws. (Tightening equipment when manual intervention is made. torque: 0.15 - 0.2 kgm) VR6: This trimmer can be used to adjust the amount of compensation of the dead band of the hydraulic valves. VR7: Spare (no function) Note: from the Electrical and Electronics When these seven trimmers are shipped Center, they are set to the central value (with the trimmer in the position shown in the diagram below). 143