Komatsu — C-19: ADJUSTING TRACK TENSION

C-l 9: ADJUSTING TRACK TENSION Precautions rease fitting After adjusting the HiC cylinder, adjust the track tension. Check that protrusion @ of hydraulic cushion cyl- inder @ is 120 ? 3 mm. (Left and right) cylinder. For details, see the procedure for adjusting the HiC Always check that stop valve @ and drain valve 0 2 are closed. inspection Raise the machine body with the boom and arm, and of the track link and the tread of the 4th track roller t,‘: measure the clearance between the roller contact surface . from the sprocket. The standard clearance is 100 - ., ,. 150 mm. ,. If the clearance is not the standard, adjust it as follows. Adjustment 1.

To increase the tension, pump in grease through grease fitting @ ; to reduce the track tension, grease out. loosen grease fitting @ one turn to let some of the 2. Grease can be pumped in to make @ 155 mm, but and bushing are worn, so it is necessary to turn or if the tension is still loose, it means that the pins replace A the pins and bushings. 100 - 150mm from the internal grease, so there is danger Grease fitting @ is under high pressure that it may fly out. For this reason, never loosen the fitting more than one turn. Never loosen any part other than grease fit- easily, move the machine a short distance ting @ . If the grease does not come out A backwards and forwards.

pumping in grease, without adjusting the If the track tension is adjusted only by hydraulic cushion cylinder, excessive load Grease cylinder 1 b Hydraulic cushion cylinder will be brought to bear on the undercar- riage and this may damage the undercar- ion cylinder @ cannot be maintained.] riage. [Stroke @ (120 f 3 mm) of cush- A Use the special handle when opening and closing stop valve @ and drain valve 0. 69