Komatsu — D-12: ASSEMBLY OF BUCKET ASSEMBLY

4. Push in the arm-bucket connecting pin, adjust with 7. Raise the link, then operate the bucket cylinder to shims (% 21N-70-14230 (tl.0) x 14) (*X 21N-70- 14240 (t0.5) x 4) (sent as individual parts) so that hole. align the position of the bucket-link connecting pin the clearance is 0.5 - 1.0 mm, then tighten the cover mounting bolts (M36). 8. Push in the bucket-link connecting pin, push in the pin, insert the shims (BEGIN-72-11230 x 3) (tl.0) & Inside of bushing: Anti-friction compound less than 1 mm, then install the stopper. (sent as individual parts) to adjust the clearance to (LM-P) 5. Assemble O-rings (%2lN-70-13150 x 2) for preven- Note: When operating the cylinder, extend it slowly.

Do not operate the cylinder suddenly or operate connection pin in the specified position, then install tion of entry of dirt and sand at the bucket-arm At first there is air inside the cylinder, so the it to the end of its stroke. 6. There are seals (209-72-I 1261 x 2) assembled to the the pin stopper. cylinder may not move for the first ten seconds. In such cases, do not operate the lever to the end to damage them when pushing in the pin. link boss (link-bucket connection). Be careful not of its travel. t The clearance at the joints should be according to the maintenance standard. After tightening once, check the torque again.

If it is loose, tighten again., Cleara Position for installing O-ring when checking clearance and aligning connecting pin hole Detail of bucket-arm connecting pin portion 86