D-l 6: BLEEDING AIR FROM CYLINDER After completion of assembly, bleed the air from the system. Run the engine at low idling, and do as follows. 1. Extend and retract each cylinder 4 or 5 times with- out going to the end of its stroke (stop approx. 100 * At first there is a large amount of air inside the mm before the end of the stroke). cylinder, so the cylinder may not move for the the lever to the end of its travel. first ten seconds. In such cases, do not operate 2.
Keep the engine running at low idling, and operate each cylinder from a point 100 mm from the end of its stroke slowly (take at least 10 seconds) to the end of its stroke (fully extended), and hold the work equipment control lever at the full stroke position for 3 minutes. 3. Next, run the engine at high idling, and operate each cylinder from a point 100 mm from the end of its stroke slowly (take at least 10 seconds) to the end equipment control lever at the full stroke position of its stroke (fully retracted), and hold the work for 1 minute. * Repeat Steps 1 - 3 to bleed the air from the cyl- inders.
* If this operation is carried out from the first with the engine running at high speed or with the cylinder operated to the end of its stroke, the air contained inside the cylinder may cause damage to the piston packing. 94