D-17: CHECK QIL LEVEL IN HYDRAULIC TANK, ADD OIL 1. Run the engine at low idling, retract the arm and the teeth are in contact with the ground, then stop bucket cylinders, lower the boom so that the tips of the engine. 2. Operate each control lever (work equipment, travel) to the end of its stroke in each direction to release the internal pressure. 3. If the oil level is not between the H and L lines on sight gauge @ , add engine oil (CD class SAEIOW regardless of ambient temperature) through oil filler @ (10 mm in height is 11 litres.) * Do not add oil above the H line.
* A Y The inside of the tank is pressurized, so loosen 4 the cap gradually, and leave for several minutes to release the air pressure completely before taking off the cap. * The oil level differs according to the oil temperature, so use the following as a guide. l Before operation: Near L line l During operation: Near H line (oil temperature: 10 - 30°C) (oil temperature: 50 - 80°C) 95