00-22 POWER TAKE OFF Cable Adjustment (PTO Side) If no specified extrusion dimensions can be obtained as a result of measuring the amount of spool extrusion de- scribed previously, adjust (PTO side) the cable so that the specified amount of spool extrusion can be obtained according to the following procedure. 1. Loosen the lock nut of the control cable. 2. Remove the tightening bolt of the cable holder. NPA0046E Legend 1. Oil pump 2. Spool extrusion 6. If the amount of spool extrusion is within a speci- fied dimension, install the shift cap and tighten the bolt at a specified torque. NPA0048E Tighten: Shift cap fixing bolt to 24 N m (2.4 kg m / 17 lb ft) Legend 1. Cable holder 2. Lock nut 3.
Bolt 4. PTO Notice: If the groove is not installed facing downward, the water intruded in the shift cap is not ejected but collected. Rusting and freezing will cause an incorrect actuation. 3. Adjust the cable rotating the cable holder. If the amount of spool extrusion is improper (in- sufficient) at “Dump lever Up”, rotate the cable holder toward “Counterclockwise rotation” shown by the arrow mark of the drawing. If the amount of spool extrusion is improper (ex- cessive) at “Dump lever Down”, rotate the cable holder toward “Clockwise rotation” shown by the arrow mark of the drawing. Notice:
Both “clockwise rotation” and “counterclockwise rota- tion” indicate that the cable moves by about 0.75 mm (0.0295 inch) every time the cable holder rotates by 180 degrees. NPA0047E Legend 1. Shift cap 2. Bolt 3. Make groove face downward