POWER TAKE OFF 00-39 Legend 1. Cable holder 2. PTO 3. Bolt 4. Control cable 7. Low-Pressure Hose Loosen the hose band and remove the hose from the oil pump. 8. High-Pressure Hose Loosen the hose joint and remove the hose from the oil pump. Notice: For the high-pressure hose, a part of the joint may not be removed according to the type of the truck and equip- ment. In that case, slightly loosen the joint to set the state. At the stage where the rear PTO is removed (Item 10), remove the high-pressure hose rotating the PTO (with oil pump). NPA0071E Legend 1. Oil pump 2. Bolt 3. Shift cap 4. Bolt (Cable Holder) 5. Cable Holder 6. Control Cable Notice:
Before removing the control cable, be sure to refer to Items 3 to 6 of “Removal” in the “Removal and Installa- tion of Control Cable for Rear Dump Truck” in the chap- ter described previously and perform work in accordance with the items. NPA0073E Legend 1. Low-pressure hose 2. High-pressure hose Notice: Because hydraulic operating fluid flows out when the hose is removed, quickly make the hose port face up- ward and protect the hose so that dust or foreign matter will not be mixed in, then fix it to the frame with a wire. NPA0072E