General Information ATV Identification Numbers The Arctic Cat ATV has two identifica- tion numbers: Vehicle Identification Number (VIN) and Engine Serial Num- ber (ESN). The VIN is located on the lower-front crossmember. Control Locations and Functions Ignition Switch ATV-0055 The ignition switch has three positions. KC0055A The ESN is located on the rear of the engine crankcase and is visible from the side. ATV-0056 OFF position — All electrical circuits except the accessory plug are off. The engine will not start. The key can be removed in this position. NOTE: The accessory plug is powered by the battery at all times.
KC287B These numbers are required by the dealer to complete warranty claims properly. No warranty will be allowed by Arctic Cat if the VIN or ESN is removed or mutilated in any way. ON position — The ignition circuit is complete and the engine can run. The key cannot be removed in this position. Always provide the ATV name, Vehicle Identification Number, and Engine Serial Number when contacting an authorized Arctic Cat ATV dealer for parts, service, accessories, or warranty. If a complete engine must be replaced, ask the dealer to notify Arctic Cat for correct registration information. Ignition Switch Key Two keys come with the ATV. Keep the spare key in a safe place.
An identifying number is stamped on each key. Use this number when ordering a replacement key. LIGHTS position — The ignition circuit is complete and the headlights and tail- light are on. The key cannot be removed in this position. CAUTION Leaving the ignition switch in the ON or LIGHTS position for a long period of time when the engine is not running may cause the battery to discharge. Always leave the igni- tion switch in the OFF position when engine is not running. 36 36 36 36