Check to make sure the emergency/park- ing brake engages properly and that the brake (when engaged) locks the wheels. Turn Signal Switch 1. Engage the emergency/parking brake. 2. Attempt to push the ATV. NOTE: The emergency/parking brake must lock the wheels. If it doesn’t, take the ATV to an autho- rized Arctic Cat ATV dealer for ser- vice. ACE-023B To activate the turn signals, slide the turn signal switch to the direction of the desired turn. When the turn is completed, press and release the turn signal switch. ! WARNING Always check to be sure that the emergency/parking brake has been disengaged before operating the ATV.
An accident could result if the emergency/parking brake is left engaged while the ATV is operated. This could cause an accident. Hazard Lights Switch Headlight Switch ACE-025B Use the headlight switch to select the high or low headlight beam or parking lights when the ignition switch is in the LIGHTS position. When the switch is in the HI position, the high beam will illu- minate. When the switch is in the LO position, the low beam will illuminate. When the switch is in the PARKING position, the front and rear lights will illuminate. Winch Switch ACE-017 To release the cable, slide the toggle switch to the left; to spool-in the cable, slide the switch to the right.
39 39 39 39 Division II - Operation/ Maintenance ACE-025A To activate the hazard lights, press and release the hazard light switch. To deacti- vate the hazard lights, press and release the hazard light switch again.