Horn Button Throttle Limiter Screw Throttle lever travel may be limited by adjusting the throttle limiter screw. The throttle limiter should be adjusted according to the operator’s skill and experience. To adjust the throttle limiter, use the following procedure. 1. Loosen the jam nut (A). ACE-023A To activate the horn, press the horn but- ton. Starter Lever ACE-028A 2. Turn the throttle limiter screw (B) clockwise to decrease engine RPM maximum or counterclockwise to increase engine RPM maximum. ACE-004E Pulling this lever activates the starter motor.
Before starting the engine, make sure the ignition switch is in the ON posi- tion, the transmission is in neutral, and the brake lever lock is engaged. NOTE: This ATV has safety inter- lock switches which prevent the starter motor from activating when the transmission is not in neutral. 3. Tighten the jam nut securely. NOTE: The ATV is equipped with an RPM limiter that retards ignition timing when maximum RPM is approached. When the RPM limiter is activated, it could be misinter- preted as a high-speed misfire. LCD (Digital) NOTE: All segments of the LCD will activate for approximately two seconds when the ignition switch is rotated to the ON position.
Throttle Lever ACE-024A Control engine RPM with the position of the throttle lever. Operate this lever with the thumb. Pushing it forward increases engine RPM and allowing it to retract decreases engine RPM. CF236B 40 40 40 40