7. If dirt or mud builds up in the track frame, raise each track and rotate and clean that track. CAUTION AVOID INJURY When using the boom and arm to lift any portion of the machine, roll the bucket until round base is against the ground. The angle of the arm to the boom must be at 90°. FG000376 Figure 37 Make sure that material buildup has been cleared. See Figure 37 and Figure 38. 8. The excavator can travel in water that comes up to center of upper carriage rollers. Make sure that footing is solid so the machine will not sink. See "Working in Water" on page 3-30. 90 ~ 110 NOTE:
If the machine is submerged to the point that water or mud gets into the swing bearing or center joint, stop machine operation. Remove machine from the submerged location to firm, dry ground. Do not operate until proper inspection and maintenance have been completed. Refer to the Shop Manual or contact your distributor. Figure 38 EX1300536 DX140R/DX140LCR Operation 3-18