Inspect Structure for Cracks and Faulty Welds 1. During the daily walk-around inspection and when greasing the machine, look for any visible damage to the machine. Repair or replace any damaged parts before operating the machine. Check Operation of All Switches 1. Verify the working condition of all switches before starting the engine. Check the Operation of Pilot Cutoff Switch A pilot cutoff switch has a pivoting safety lever that deactivates the work group, swing and travel control functions. When the safety lever is moved down into "LOCK" position, the work group, swing and travel control functions are deactivated.
Unlock When the safety lever is moved up into "UNLOCK" position, the work group, swing and travel control functions can be operated. EX1300566 Figure 37 WARNING Lock The PILOT CUTOFF SWITCH (safety lever) must deactivate the work group, swing and travel control functions when the safety lever is moved down into "LOCK" position. AVOID DEATH OR SERIOUS INJURY Contact your DOOSAN distributor immediately if the controls do not deactivate. DO NOT MODIFY THE SYSTEM. Inspection and Maintenance of the Pilot Cutoff Switch 1. Check for and keep bystanders away from the work area. Sit in operator's seat and fasten seat belt. 2. Start engine and move safety lever up into "UNLOCK" position. 3.
Operate the work group (joystick) levers in all directions to check that the boom, arm, bucket (or other attachment) and swing functions operate correctly. Also, check that the travel controls operate properly. NOTE: Hydraulic system must be warmed up to operating temperatures. 4. Raise the boom and arm so the bucket (or other attachment) is about 1 m (3 ft.) off the ground. 5. Move the safety lever down into "LOCK" position to deactivate the work group and travel functions. Move the work group (joystick) levers. There must be no movement Inspection, Maintenance and Adjustment 4-25 DX140R/DX140LCR