Doosan DX140R/DX140LCR — Check Operation of All Exterior Lights, Horn and Control Console Indicator and Monitor Lights

of the boom, arm, and attachment or swing functions when the controls are moved. 6. With the safety lever still in the "LOCK" position, move the travel controls. There must be no movement of the excavator tracks. 7. Move safety lever up into "UNLOCK" position. Raise the boom so the bucket (or other attachment) is about 3 m (10 ft.) off the ground. Operate the work group (joystick) lever to lower the boom slowly. While boom is lowering, move the safety lever down into "LOCK" position. Boom movement must stop. Repeat these steps for arm, bucket (attachment), swing and travel functions. 8. Lower work group to the ground and stop engine. NOTE:

If the PILOT CUTOFF SWITCH (safety lever) does not deactivate the work group and travel functions as described above or if any parts are damaged, bent or missing, contact your DOOSAN distributor immediately for service. DO NOT MODIFY THE SYSTEM. Check Operation of All Exterior Lights, Horn and Control Console Indicator and Monitor Lights 1. Turn engine starter switch toI" (ON) position and observe all of the indicator lights. 2. Restore operation of any light bulbs that do not turn "ON" at this time. 3. Sound the horn. Repair or replace if required. 4. Turn "ON" and inspect all exterior work lights. Replace any monitors, burned out bulbs or cracked or broken housings or lenses.

DX140R/DX140LCR Inspection, Maintenance and Adjustment 4-26