Doosan DX140R/DX140LCR — Inspect Track Assemblies for Proper Tension and Loose, Worn or Damaged Parts (Links, Shoes, Rollers, Idlers)

Grease Dozer Blade Pin (Optional) NOTE: Grease it per 10 hours during initial period of 100 hours after buying your new machine, after which period grease it per 50 hours. NOTE: In case of performing work underwater, grease it per 10 hours irrespective of elapsed period. 1. Lower dozer blade to the ground. 2. Inject grease at total 6 points by 3 points per dozer cylinder by means of using grease gun. FG009564 3. Neatly remove old grease that has leaked out after greasing. Figure 42 Drain Water and Sediment from Fuel Tank 1. Perform this procedure before operating the machine. 2. Drain water and sediment from bottom of fuel tank into a suitable container. NOTE:

Dispose of drained fluid according to local regulations. NOTE: Always completely fill fuel tank at end of each workday to prevent condensation from forming on the inside walls of the tank. FG014426 Figure 43 Check Engine Fan Belt for Cracks, Wear and Correct Tension (After First 50 Hours) 1. Inspect after first 50 hours of operation and every 250 hours thereafter. For details, See "Check Engine Fan Belt Tension" on page 4-33. Inspect Track Assemblies for Proper Tension and Loose, Worn or Damaged Parts (Links, Shoes, Rollers, Idlers) 1. Do a daily walk-around inspection of all components including the track assemblies. Look for missing, damaged or excessively worn parts.

See "Track Tension" on page 4-79. 2. Jack up each track and perform the two speed travel motor test. DX140R/DX140LCR Inspection, Maintenance and Adjustment 4-30