3. Remove coolant drain plug (1, Figure 106) from engine. 4. Install drain plug, and close drain valve after coolant has completely drained from system. 6. Run engine at low idle until the coolant temperature gauge reaches the "BLUE ZONE". Run engine for another ten minutes. 5. Fill cooling system with a flushing solution. 7. Allow engine to cool. 8. Drain flushing fluid and fill system with water. FG014441 Figure 106 9. Run engine again to allow water to completely circulate. 10. After allowing engine to cool, drain water and fill system with proper antifreeze mixture for ambient temperature. Refer to coolant concentration table. See "Antifreeze Concentration Tables" on page 4-74. 11.
Run engine without radiator cap installed, so that all air will be purged from system. Fill radiator to fill neck. 12. Drain and fill radiator coolant recovery tank. NOTE: When refill or replace coolant, select "heater-full hot" mode to fully open the water valve. Coolant will then flow into the heater's core to prevent air from being trapped in it. Figure 107 EX1502246 Inspection, Maintenance and Adjustment 4-59 DX140R/DX140LCR