Doosan DX140R/DX140LCR — Hydraulic Oil Exchange and Suction Strainer Cleaning

5. Drain hydraulic oil from tank into a container capable of holding 147.8 liters (39 U.S. gal.). After draining tank, install drain plug. IMPORTANT Be careful of squirting oil when removing drain plug. NOTE: Used filter and used oil should always be disposed of according to local regulations. FG014419 Figure 110 6. Carefully remove bolts and cover (2, Figure 112) from top of hydraulic oil tank. There is a spring (3) under the cover that will force the cover up. 7. Remove spring (3, Figure 112) and strainer (5), by pulling on rod (4). A 8. Clean inside and outside of strainer. Replace strainer if it is broken. 9. Position strainer (5, Figure 112) on boss portion of suction pipe (6). NOTE:

Measurement "A" is 735 mm (25.59 in). Figure 111 HAOC411L 10. Fill the hydraulic oil tank. Check level using sight gauge on side of tank. 1 11. Place spring (3, Figure 112) on rod (4) and assemble cover (2). 2 12. After replacing and cleaning the hydraulic oil, filter and strainer, vent the system. See "Venting and Priming Hydraulic System" on page 4-81. 3 IMPORTANT 4 When the hydraulic breaker is being used, because of the higher heat generated by this unit, use replacement intervals recommended under the "Hydraulic Oil and Filter Service Intervals" on page 3-37. 5 13. Check level of hydraulic oil tank.

(See page 4-17) 6 ARO1720L Figure 112 Inspection, Maintenance and Adjustment 4-61 DX140R/DX140LCR