Inspection, Maintenance and Adjustment 4-77 DX140R/DX140LCR 1. Remove strainer cap (4, Figure 124) from strainer (3) on end of inlet hose (5). NOTE: Keep strainer cap (4, Figure 124) in a safe location to reseal strainer (3) after refueling is complete. 2. Insert inlet hose (5, Figure 124) into refueling tank. 3. Turn fuel pump switch (Figure 125) inside of battery box on front side to "I" (ON) position. NOTE: Transfer pump rate of flow is approximately FG014602 35 lpm (9.24 U.S. gpm). Use extra care not to Figure 125 overfill fuel tank so fuel does not over flow. 4. Once fuel transfer is completed, immediately turn switch to "O" (OFF) position to stop pump. 5.
Lift inlet hose (5, Figure 124) from fueling source and turn switch to "I" (ON) position for two - three seconds to drain remaining fuel from hose to fuel tank. 6. Install strainer cap (4, Figure 124) on inlet strainer (3) and return hose (5) to storage position. FG014602 FG014602