Doosan DX140R/DX140LCR — Track Tension

TRACK TENSION WARNING AVOID DEATH OR SERIOUS INJURY Measuring track tension requires two people. One person must be in the operator's seat, operating the controls while the other person makes dimensional checks. Block frame to make sure the machine won't move or shift position during service. Warm up the engine to prevent stalls, park the excavator in an area that provides level, uniform ground support and/or use support blocks when necessary. NOTE: The track tension must be adjusted in accordance with the operating conditions. If a lot of dust stick to the track assembly in the working place, keep the track as loose as possible.

Track shoe link pins and bushings wear with normal usage, reducing track tension. Periodic adjustment is necessary to compensate for wear and it may also be required by working conditions. 1. Track tension is checked by jacking up one side of the excavator. See Figure 127. Place blocking under frame while taking measurement. Turn the track backward 1 ~ 2 turns. 90 ~ 110 EX1300536 Figure 127 2. Measuring the distance (A, Figure 128) between the bottom of the side frame and the top of the lowest crawler shoe. Recommended tension for operation over most types of terrain is as below table. NOTE: Clean off the tracks before checking clearance for accurate measurements. 3.

Too little sag in the crawler track (less than clearance distance "A" on below table) can cause excessive component wear. The recommended adjustment can also be too tight causing accelerated stress and wear if ground conditions are wet, marshy or muddy. A FG000162 Figure 128 Inspection, Maintenance and Adjustment 4-79 DX140R/DX140LCR