4. A track that is properly adjusted may have a different sag according to the track options. Contact your dealer for information. WARNING AVOID DEATH OR SERIOUS INJURY The track adjusting mechanism is under very high-pressure. NEVER release grease pressure too fast. The track tension grease valve should never be loosened more than one (1) complete turn from the fully tightened down position. Bleed off grease pressure slowly. Keep your body away from the valve always. Always wear eye and face protection when adjusting track tension. 5. Track tension adjustments are made through the grease fitting (1, Figure 129) in the middle of each side frame.
Adding grease increases the length of an adjustment cylinder (2). Extending the adjustment cylinder, increases the pressure on the tension spring pushing the track idler wheel outward. 2 1 6. If there is not enough slack or clearance in the tracks and the adjustment is too tight, the idler wheel and adjusting cylinder can be retracted by bleeding off grease through hole in adjustment cylinder (2, Figure 129). 3 FG019868 Figure 129 DX140R/DX140LCR Inspection, Maintenance and Adjustment 4-80 Terrain Type Distance "A" Normal 275 ~ 305 mm (10.8 ~ 12.0 in)