MACHINE OPERATIONS AND CONTROLS OPERATION REMARK When installing the bucket, the O-rings are easily damaged, so fit the O-rings on the boss of the arm end as shown in the dia- gram. When knocking the pin, move the O-ring down to the regular groove. 4. Install the ring plates and stopper pins to each pin. Add grease through fittings (D), (E), and (F)(total: 5 points) on the bucket link. Inversion 1. Place the bucket in contact with a flat surface. REMARK When removing the pins, place the bucket so that it is in light contact with the ground. If the bucket is lowered strongly to the ground, the resistance will be increased and it will be difficult to remove the pins.
NOTICE After removing the pins, make sure that they do not become contaminated with sand or mud and that the seals of bushing on both sides do not become damaged. 2. Remove the ring plate and stopper pin, then pull out pins (A) and (B), and remove the bucket. 3-74