MAINTENANCE PROCEDURE MAINTENANCE 4. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE When cleaning the element, do not hit it or beat it against something . Do not use an element whose folds or gasket or seal are damaged. Wrap unused element and store them in a dry place. 5. Install the cleaned element and fix it with the wing nut. 6. Replace seal washer (4) or wing nut (2) with new parts if they are broken. 7. Remove evacuator valve (5) and clean with compressed air. After cleaning, install it. 8. Press the button of dust indicator 1 to return the red piston to its original position.
Replacing inner element 1. First remove wing nut (2) and the outer element, and then remove the inner element. 2. To prevent dust from getting in, use a clean cloth or tape to cover the air connector (outlet side). 3. Clean the air cleaner body interior, then remove the cover installed in Step 2. 4. Fit a new inner element to the connector and tighten it with nuts. Do not clean and reinstall a inner element. Tightening torque: 4.9 to 5.88 N•m(0.5 to 0.6 kgf•m, 3.6 to 4.3 lbft) 5. Set the outer element in position and secure it with the wing nut. 6. After replacing the element, press the button of dust indicator to return the red piston to its original position. 4-22