Komatsu — COOLING SYSTEM COOLANT-CLEAN/CHANGE

MAINTENANCE PROCEDURE MAINTENANCE Mixing rate of water and antifreeze -30 -22 5.2 1.37 1.14 5.1 1.35 1.12 WARNING Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. W When removing the drain plug, be careful not to get water containing antifreeze on you. I If it gets in your eyes, flush your eyes with large quantities of fresh water and see a doctor at once. Use city water for the cooling water. If river water, well water or other such water supply must be used, contact your Komatsu distributor. We recommend use of an antifreeze density gauge to control the mixing proportions.

Prepare a container with a capacity of at least 10.3 liters to catch the mixture of water and antifreeze. Prepare a hose to supply water. 1. Stop the engine. 2. Turn radiator cap (1) slowly and remove it. 3. Remove the undercover, then set the container under drain valve (2) and drain plug (3) to catch the coolant mixture. Open drain valve (2) at the bottom of the radiator and drain the coolant. Then open drain plug (3) in the cylinder block and drain the coolant. 4. After draining the coolant, close drain valve (2) and drain plug (3), and fill with city water.

When the radiator is full, start the engine and run at low idling to raise the temper- ature to at least 90°C, then continue to run for approx. 10 minutes. 5. Stop the engine, open drain valve (2) and drain plug (3), and drain the water. 6. After draining the water, clean the radiator with detergent. For the cleaning method, follow the instruction of deter- gent. 4-24 Min. atmospheric temperature °C -10 -15 -20 -25 °F 14 5 -4 -13 Amount of antifreeze liters 3.1 3.7 4.2 4.7 US gal 0.82 0.98 1.11 1.24 UK gal 0.68 0.81 0.92 1.03 Amount of water liters 7.2 6.6 6.1 5.6 US gal 1.90 1.74 1.61 1.48 UK gal 1.58 1.45 1.34 1.23