MAINTENANCE MAINTENANCE PROCEDURE 7. Close drain valve (2), then wrap drain plug (3) with sealing tape and close it. 8. Install the undercover. 9. Add water through the water filler up to the filler port. 10. Run the engine idle at a low speed for 5 minutes, then at a high speed for 5 minutes to bleed air mixed in the cooling water. (At this time, keep the water filler cap removed.) 11. After draining off the cooling water of reserve tank (4) , clean the inside of the reserve tank and refill the water between FULL and LOW level. 12. Stop the engine, wait for about three minutes, add cool- ing water up to near the radiator water filler port, then tighten cap. 4-25