Komatsu — FINAL DRIVE CASE OIL-CHANGE

MAINTENANCE MAINTENANCE PROCEDURE Final Drive Case Oil - Change WARNING The oil is at high temperature after the engine is stopped. Wait for the temperature to go down before starting the operation. If there is pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Container to catch drained oil: Min. 1.7 liters capacity Refill capacity: 1.7 liters (0.45 US gal, 0.38 UK gal) Hexagon wrench (Width across flats: 8 mm (0.3 in)) 1. Set plug (F) at the top, with plug (F) and plug (P) perpen- dicular to the ground surface. 2. Set a container under plug (P) to catch the oil. 3.

Remove plugs (P) and (F) with the hexagon wrench and drain the oil. 4. Tighten plug (P). 5. Add engine oil trough the hole of plug (F). 6. When the oil overflows from the hole of plug (F), install plug (F). 4-67