MAINTENANCE PROCEDURE MAINTENANCE 5. Remove the cover over the hydraulic tank and remove the cap of oil filler (F). 6. Set the oil container under the drain plug under the machine.Using the handle, remove drain plug (P) and drain the oil.Check the O-ring installed to plug (P), and if it is damaged, replace the O-ring. After draining the oil, tighten drain plug (P). Tightening torque: 68.6±9.81 N•m (7±1 kgf•m, 50.6±7.2 lbft) Take care not to get oil on yourself when you remove drain plug (P). 7. Loosen 4 bolts, then remove cover (1) . When doing this, the cover may fly out under the force of spring(2) , so push the cover down when removing the bolts. 8.
Pull up the top of rod (3) , and remove spring (2) and strainer (4) . 9. Remove the dirt stuck to strainer (4) , then wash it in clean diesel oil or flushing oil. If strainer (4) is damaged, replace it with a new one. 10. Refit strainer (4) by inserting it into tank projecting part (5). 11. Install cover (1) with bolts. Check the O-ring installed to cover (1) , and if it is dam- aged , replace the O-ring. 12. Add the specified amount of new and clean engine oil (for hydraulic system) through oil filler port (F). Check that the oil level is between H and L on the sight gauge. For details of oil level check, see "Hydraulic Oil Level - Check/Add (PAGE 3-39)". 13.
Extend the boom, arm, and bucket cylinder fully as shown in the diagram on the right, remove the oil filler cap, then install the cap and pressurize the inside of the tank. NOTICE Be sure to pressurize the hydraulic tank. If it is not pres- surized, the pump will suck in air, and this will adversely affect the equipment. 14. After replacing hydraulic oil and cleaning or replacing fil- ter element and strainer, bleed air from the circuit. For details of the method of bleeding the air, see "Hydraulic System - Bleed Air (PAGE 4-47)". 4-72