MACHINE READY FOR ATTACHMENT ATTACHMENTS AND OPTIONS HYDRAULIC CIRCUIT Hydraulic Circuit Connection When connecting the attachment, connect the hydraulic circuit as follows. One Line Attachment 1. Check that the stop valve is locked, then remove plug (1) .Be careful not to lose or damage any parts that are removed. 2. Connect the attachment piping supplied by the attach- ment manufacturer. Depending on the piping for the attachment, it may be necessary to remove nipple (2) .
The dimensions for nipple 2 and elbow 3 for the attach- ment at the stop valve end are as shown in the diagram on the right; for details of the dimensions at the attach- ment end, please consult the attachment manufacturer. 3. After connecting the piping, bleed the air from the circuit. 1) Start the engine and run it at low idling for 10 min- utes. For details, see "STARTING ENGINE (PAGE 3-47)". Then carry out the following operation. 2) Run the engine at low idling until the air in the attach- ment circuit is completely removed, then operate the attachment pedal repeatedly (approx. 10 times) to bleed the air.
NOTICE If the attachment maker specifies an air bleeding proce- dure for the attachment itself, follow the specified proce- dure to bleed the air. 3) After completing the bleeding of the air, stop the engine, and wait for at least 5 minutes before starting operations. This will release the bubbles in the oil inside the tank. 4) Check that there is no oil leakage, and wipe off any oil that has been spilled. 6-20