ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Two Line Attachment When connecting the attachment, connect the circuit as follows. 1. Bleed the air from the attachment circuit as follows. 1) Lower the work equipment to the ground. 2) After stopping the engine, turn the starting switch to the ON position. 3) Operate the left pedal to the end of its travel approx. 10 times to release the pressure in the circuit. Note that this does not completely release the pres- sure, so when connecting the piping, loosen the con- nections slowly and do not stand in the direction where the oil spurs out.
4) Turn the starting switch to the OFF position, and place the safety lock lever and lock pin in the LOCK position. 2. Remove nut (1) and plug (2) from the tip of the tube. Be careful not to lose or damage any part that is removed. 6-21