Komatsu — ATTACHMENT COMBINATIONS

ATTACHMENT GUIDE ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE ATTACHMENT COMBINATIONS This table lists the combination of attachments which can be installed to the standard arm, short arm and long arm. : Can be used : Can be used only for light duty work : Cannot be used NOTICE When the long armis equipped, if the bucket is pulled in to the machine body, the arminterferes with the body. Operate the long arm carefully. When the boom is fully lowered during oblique digging, the boom interferes with the undercarriage. Operate the boom carefully. Categories of use For general digging: Digging or loading sand, gravel, clay etc. For light duty digging:

Digging or loading dry, uncaked earth and sand, mud etc. For loading work: Loading dry, loose earth and sand 6-30 Name Tooth mounting pin Model Capacity Outside width Use Stan- dard arm Long arm PC60 SAE m3 (cu.yd) CECE m3 (cu.yd) Bucket body mm(in) Side cutter mm(in) Narrow bucket Bucket OPT. 0.09 (0.10) 0.08 (0.10) 350(14'') 450(18'') Narrow digging Narrow bucket Vertical OPT. 0.13 (0.14) 0.11 (0.14) 450(18'') 550(22'') Narrow digging Narrow bucket Vertical OPT. 0.20 (0.23) 0.18 (0.23) 550(22'') 650(26'') Narrow digging Standard bucket Vertical Standard 0.28 (0.32) 0.25 (0.32) 650(26'') 750(30'') General digging Horizontal OPT. Strengthened bucket Vertical OPT.

0.28 (0.32) 0.25 (0.32) 650(26'') 750(30'') Heavy duty digging Horizontal OPT. Light duty bucket Vertical OPT. 0.36 (0.41) 0.32 (0.41) 725(29'') 825(33'') Loading