Komatsu — CONTROLLER

ATTACHMENTS AND OPTIONS AUTOMATIC GREASING SYSTEM AUTOMATIC GREASING SYSTEM CONTROLLER If any abnormality occurs in the controller, do not repair it yourself. See "OTHER TROUBLE (PAGE 3- 106)", and report the content when contacting your Komatsu distributor for repairs. WARNING When operating the controller, consult first with your Komatsu distributor. This is on the left side inside the engine room. This controller is used to control the automatic greasing system. This is on the left side inside the engine room. This controller is used to control the automatic greasing sys- tem.

Setting Greasing Interval If the work equipment is used for long periods under particularly severe conditions or in riverbed work where a large amount of grease flows out, the greasing interval should be reduced. In such cases, if it is desired to carry out greasing more frequently than the interval set when the machine was shipped from the factory, it is possible to change the set value of the controller as follows to reduce the greasing interval. The greasing interval is set at 5 hours when the machine is shipped from the factory. Remember that if the greasing interval is reduced, the length of time that the grease cartridge can be used is also reduced.

Furthermore, if the greasing interval is reduced, there will be an increase in the amount of grease drip- ping from the end face of the work equipment pins and this may make the machine dirty or contaminate the sur- rounding area. REMARK If the greasing controller or greasing pump should be damaged and stop working, greasing can still be carried out with a grease gun through the fitting of the divider valves (3 points). The greasing locations for the automatic greasing control- ler are the places shown in the diagram on the right.

Bucket-link connecting pin (2 places) Link connecting pin (2 places) Bucket cylinder rod end (1 place) Use a grease gun to grease the following places every 100 hours. 6-31