OPERATION 12.17.7 MULTI-PURPOSE BUCKET IN SCRAPER POSITION 1. To use the multi-purpose attachment for scraper loading, place the bucket on the ground. Open the clam until the indicator points to (1) or (2) setting on the indicator, depending on the desired depth of the cut. 2. Tilt the bucket forward or backward. Proceed to go forward. The moldboard cutting edge will enter the ground until the clam cutting edge makes contact. Continue to go forward until the bucket is filled. 3. Tilt the bucket back, closing the clam in the same motion. Raise the bucket above the ground and proceed to the dumping area. 4. Upon reaching the truck, raise the bucket high enough to clear the truck body.
Reduce forward speed and dump load slowly. This will reduce the shock of weight to the rear axle when the bucket is emptied. Shake bucket only to loosen dirt from within. After the bucket empties, move the bucket control lever back until the bucket clears the truck. Back the loader away from the truck, lower the boom and return to the loading sight. NOTE: Lower loaded or unloaded bucket to the ground when waiting for any length of time. 2-65