Komatsu — 12.17.8 PALLET FORKS

OPERATION 12.17.8 PALLET FORKS GENERAL Terrain, footing conditions, size and type of materials being moved, and maneuvering space determine the speed at which the fork lift can function. When the fork lift is at work, keep the engine speed near full throttle and operate the first or second gears. Use the 3rd or 4th gears for traveling purposes. The techniques for using the fork lift as described below are not intended to be all inclusive. Each work situation will vary. Fork lift operation maybe altered for each particular application for best efficiency. LOADING WARNING C Know the rated capacity of the fork lift. Do not overload it.

C Never pick up a load until certain it can be carried safely. C The load must be steady on the forks before lifting. C Always keep the load against the carriage back rest 1. When loading the fork lift, position the tractor squarely with the load, and then slowly engage the load with forks. The forks should be level and centered between the pallet stringers, and as far apart as the load permits, for added stability. Slowly move forward until the forks fully engage the load, and the load touches the tine boom. 2. Pull the lift control lever back to raise the loaded forks several inches to clear the ground or stack. Tilt the carriage to the rear to get the load against the carriage backrest.

3. Back out slowly while looking back to ensure there are no obstacles. When the load is clear, keeping the load against the carriage backrest, lower the load close to the ground (approximately 30 inches of ground level). Transport the load to the unloading area. 2-70