OPERATION TRANSPORTING WARNING C Before transporting the load it must first be tilted back against the carriage backrest and then lowered close to the ground. This will prevent the load from accidentally sliding off the forks. C The angle of tilt back will depend upon the type of load. Too large an angle could cause rearward spillage of the load. WARNING When traveling, descend steep hills or ramps in reverse. Avoid sharp turns at too high of a speed, which could the load to slip or tip the vehicle. 1. Normally the load is transported close to the ground. If it is necessary to carry the load raised while in transit, the operator should use increased caution.
Perform all steering and shifting as smoothly as possible. 2. Use 1st and 2nd gears for fork loading and transportation of loads, and 3rd and 4th gears may be used for making return trips to the loading area. 3. The speed used to transport loads should be relative to fork carry position and the type of route used. Safety should be considered at all times. Travel slow a load is carried over rough or sloping footing. If a load restricts forward visibility, travel in reverse. 4. Keep the load position tilted uphill when climbing or descending a grade. 2-71