Komatsu — 12.19.1 ADJUSTING BOOM KICK OUT

OPERATION 12.19 ADJUSTING BOOM KICK-OUT POSITIONER WARNING ! Stop the machine on flat ground and put blocks in front and behind the wheels. ! Apply the parking brake. ! Secure the front and rear frames with safety bar. ! Never go under the work equipment when the arm is raised. The boom kick out makes it possible to set the bucket or fork so that they automatically stop at the desired lifting height (work equipment higher than horizontal), the bucket positioner makes it possible to set the bucket so that it automatically stops at the desired digging angle, the fork positioner makes it possible to set the fork so that it automatically stops at the desired lifting angle.

The settings can be adjusted to match the working conditions. 12.19.1 ADJUSTING BOOM KICK OUT 1. Raise the bucket to the desired height, Set the work equipment control lever at Hold and lock the lever in position. Then stop the engine and adjust as follows. 2. With the boom at the desired position, mark it at the position where the center of the switch is at the top end of the boom plate. 3. Adjust the position of the plate so that the center of the proximity switch (1) is in line with the top of the boom plate (2), then secure in position. Plate mounting bolt tightening torque: (88.3 ± 34.3 Nm (9 ± 3.5 kgm) 4.

Adjust the proximity switch (1) so that the clearance “a” between the switch (1) sensing surface and the boom plate (2) is 3 to 7 mm (0.12 to 0.20 in.), then secure the switch in this position. Note: After adjusting, operate the boom lever and check that the kick-out is actuated at the desired position. 2-76