Komatsu — 12.19.2 ADJUSTING BUCKET/FORK POSITIONER

OPERATION 12.19.2 ADJUSTING BUCKET / FORK POSITIONER 1A. While the machine is equipped with the bucket attachment, switch attachment switch on cab console to bucket position to adjust forward proximity switch. 1B. While the machine is equipped with the fork attachment, switch attachment switch on cab console to fork position to adjust the rear proximity switch. 2A. Lower the bucket to the ground, operate the bucket to the desired digging angle, then return the lever to the “HOLD” position, and stop the engine. 2B. Lower the fork to the ground, operate to level position, then return the lever to the “HOLD” position, and stop the engine. 3.

Adjust the clearance between bracket (1) and detection bar (2) 0.5 - 2.0 mm (a) , then secure the bracket in position. 4. Secure support (3) to the bucket cylinder bracket so the tip of detection bar (2) is in line with the center of the switch sensing surface. 5. Adjust the switch clearance between the switch sensing surface and detection bar (2) is 3 - 7 mm (b) , then secure the position. NOTE: Switch mounting nut torque: (17.7 ± 2.0 Nm (1.8 ± 0.2 kgm) 6. After adjusting, start the engine and raise the lift arm.

Operate the work equipment control lever to the DUMP position, then operate it to the TILT position and check that the work equipment control lever is automatically returned to HOLD when the bucket or fork reaches the desired angle. 2-77