OPERATION 12.2 CHECK BEFORE STARTING Always carry out the items in this section before starting the engine each day 12.2.1 CHECK COOLANT LEVEL, ADD COOLANT WARNING Always wait for the engine to cool down before checking the water level, and check using the radiator overflow sub-tank 1. Open the engine left hand side cover and check that the coolant level is between the FULL and LOW marks on the subtank (1). If the coolant level is low, add coolant to the FULL mark through the filler in the subtank. For access to the filler (1) open the door on top of the hood behind the rear cab window. For complete coolant specifications ц see 20.3 COOLANT SPECIFICATIONS on page 3-13 2.
After adding coolant then tighten cap securely. 3. If sub-tank (1) is empty, check for coolant leakage, then add coolant to the radiator and sub-tank. 12.2.2 CHECK MONITOR PANEL 1. Turn the starting switch to ON. 2. Check that all the monitor lamps, the gauges and the warning lamp light up for about 3 seconds and the buzzer sounds for about 1 second. If any monitor lamp does not light up, ask your distributor to inspect the monitor lamp. Do not carry out the CHECKS BEFORE STARTING using only the monitor; always carry out also the items specified for the periodic maintenance. 2-33