OPERATION 12.2.3 CHECK FUEL LEVEL, ADD FUEL WARNING When adding fuel, never let the fuel overflow. This could cause a fire, thoroughly clean up any spillage. 1. Turn the engine starting switch to the ON position, then check the fuel level on the fuel gauge (G). After checking, return the starting switch to the OFF position. 2. Add fuel through filler (F). For details of the method for opening and closing the cap, see "11.5 CAP WITH LOCK" on page 2-24 For details of the fuel to use, see "20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE" on page 3-10 3. After adding fuel, tighten cap securely. FUEL CAPACITY: 184 R (48.6 US gal, 40.5 UK gal) NOTE:
To eliminate moisture or corrosion in the fuel tank, it is recommended that fuel tank always be filled before storing the machine until the next work operation. 12.2.4 CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine side cover at the right rear side of the machine. 2. Remove dipstick (G) and wipe the oil off with a clean cloth. 3. Insert dipstick (G) fully in the guide tube, then take it out again. 4. The oil level should be between the ADD and FULL marks on the dipstick. If the oil is below the ADD mark, add engine oil through oil filler (F). Oil specifications ц SEE "20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE" on page 3-10 5.
If the oil is above the FULL mark, drain the excess engine oil from the drain plug (P), and check the oil level again. 6. If the oil level is correct, tighten the oil filler cap securely and close the engine cover. REMARKS When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 2-34