1.9 CRANKSHAFT ASSEMBLY 9. Measure the shaft length of the main bearing-cap bolts. Replace any bolts that exceed the maximum shaft length of 156.0 mm (6.14 inches). See Figure 1-47. 1. Main Bearing-Cap Bolt Figure 1-47 Measuring a Main Bearing-Cap Bolt 10. Lubricate the main bearing-cap bolts with a light coating of clean engine oil. Install all the M18 x 2 main bearing-cap bolts, in the correct order, as removed. Tighten each one in four stages, listed in Table 1-12, stage by stage. Table 1-12 Tightening Stages, Main Bearing-Cap Bolts 11. Measure the crankshaft end play (fore-to-aft motion) at the center bearing journal. Refer to section 1.9.2.1. 12. Install the pistons.
Refer to section 1.17.2. 13. Install the oil pump and oil pan. Refer to section 3.4.3. Refer to section 3.1.2. 14. Install the flywheel and flywheel housing. Refer to section 1.12.2. 15. Install the front cover housing. Refer to section 1.10.2. All information subject to change without notice. 1-64 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Max. Shaft Length: mm (in.) Tightening Stage Torque Value: N·m (lb·ft) 156.0 mm (6.14 in.) Stage 1 100 (74) 156.0 mm (6.14 in.) Stage 2 200 (148) 156.0 mm (6.14 in.) Stage 3 300-330 (221-243) 156.0 mm (6.14 in.) Stage 4 90 degrees