MBE 4000 SERVICE MANUAL 16. Install the cylinder heads. Refer to section 1.2.2. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. 17. Remove the engine from the stand. 18. Install the engine. 1.9.2.1 Crankshaft Measuring and Inspection Inspect the crankshaft as follows: 1. Remove the crankshaft. Refer to section 1.9.1. 2. Clean the crankshaft with a chamois. 3. Check the crankshaft for condition.
If cracks or fissures are found, replace the crankshaft. 4. Using the hardness tester (000 589 53 21 00), test the hardness of the journals. Each journal must pass the hardness test at two thirds of its circumference. If it doesn't, either replace the crankshaft, or have it re-hardened. [a] Place a hard base underneath the bearing journal to be tested. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-65